
DMDVB20 LBST Satellite Modem User Interfaces
TM138 – Rev. 1.0 4-9
LOW ALARM THRSH {0.00 Volts}
Allows user to select lower alarm limit/threshold for BUC
voltage.
HI ALARM THRSH {0.00 Volts}
Allows user to select high alarm limit/threshold for BUC
voltage.
LOW ALARM THRSH {0.00 Amps}
Allows user to select lower alarm limit/threshold for BUC
current.
HI ALARM THRSH {0.00 Amps}
Allows user to select high alarm limit/threshold for BUC
current.
CAR DLY (SEC) {0 to 255}
Allows the user to select the time delay after power-up before the Tx Carrier may be
enabled. This allows time for the BUC to stabilize.
ADDRESS Allows user to enter the BUC address to establish
FSK communications between the modem and BUC.
(Only available when the FSK Comm is Enabled)
BUC OUTPUT {Enable/Disable}
(Only available when the FSK Comm is Enabled)
Enables or Disables the BUC RF Output.
FSK TEST {NONE, PASSTHRU, QUERY FOR ADDRESS,
LOOPBACK, CYCLE TX ENABLE, }
(Only available when the FSK Comm is Enabled)
NONE:
This is the none FSK operational mode.
LOOPBACK:
The FSK will initiate an internal loopback test of the FSK
transmitter and receiver verifying that the modem
communication link is functioning properly.
CYCLE TX ENABLE:
The modem will initiate a test of the FSK between the
modem and BUC. The LBST will enable and disable the
BUC RF output and verify that the commands are
properly received and accepted by the BUC and the
modem. If communications are lost, LBST will initiate a
fault.
QUERY FOR ADDRESS:
The modem will initiate a FSK query requesting BUC
address.
Comentarios a estos manuales