Radyne DMDVB20 LBST Instrucciones de operaciones Pagina 61
- Pagina / 113
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
DMDVB20 LBST Satellite Modem User Interfaces
TM138 – Rev. 1.0 4-25
10 Mbps/HD – for 10 Base-T in either half-duplex or full
duplex.
HW/FW CONFIG (menu)
FIRMWARE REV Displays the installed firmware revision.
M&C REV Displays the installed Monitor and Control revision.
MAIN BOARD (menu)
Only the appropriate of the VCO adjustment screens listed below will be
displayed. These are protected fields, to prohibit accidental changes. To
edit the field, the user must depress all four of the direction arrow keys
simultaneously.
INT VCO ADJUST {0% - 100%}
Allows the user to adjust the internal frequency
reference for calibration. Only displayed of the system
reference clock is INTERNAL.
HI STAB VCO ADJUST {0% - 100%}
Allows the user to adjust the internal frequency
reference for calibration. Only displayed if the system
reference clock source is HI STABILITY.
LARGEST HB GAP Used for factory test only.
SOFT RESET {Enter}
IF BOARD (menu) Indicates the Radyne part number for the IF Board
Assembly.
AGC/CTRL/VALUE {0% - 100%}
Allows the user to adjust the internal frequency
reference for calibration. Only displayed if the system
reference clock source is HI STABILITY.
I OFFSET Used for factory test only.
Q OFFSET Used for factory test only.
LB RX LVL OFFSET Used for factory test only.
POWER SOURCE Used for factory test only.
- DMDVB20 LBST 1
- Warranty Policy 2
- Preface 4
- Trademarks 5
- Copyright 5
- Disclaimer 5
- Record of Revisions 5
- Table of Contents 6
- TM138 – Rev. 1.0 ix 8
- TM138 – Rev. 1.0 xi 10
- Introduction 12
- 1.1.1 Feature Upgrades 13
- 1.1.3 Hardware Options 13
- 1.2 Function Accessibility 13
- TM138 – Rev. 1.0 1-3 14
- Installation 15
- 2.1 Unpacking 16
- 2.2 Removal and Assembly 16
- 2.3 Mounting Considerations 17
- 2-4 TM138 – Rev. 1.0 18
- 2.5 Modulator Checkout 19
- 2.5.1 Initial Power-Up 19
- 2.6 Storage 19
- 2-6 TM138 – Rev. 1.0 20
- Theory of Operation 21
- 3-2 TM138 – Rev. 1.0 22
- 3.1.1 Front Panel 24
- 3.1.2 Baseband Processing 24
- TM138 – Rev. 1.0 3-5 25
- 3-6 TM138 – Rev. 1.0 26
- 3.3 Internal Clock 27
- TM138 – Rev. 1.0 3-9 29
- 3.5 Clocking Options 30
- 3.5.1 TX Clock Options 30
- 3.5.2.1 RX SAT Clock 32
- 3.7.3 Interleaving 33
- 3-14 TM138 – Rev. 1.0 34
- TM138 – Rev. 1.0 3-15 35
- 3-16 TM138 – Rev. 1.0 36
- User Interfaces 37
- 4.1.3 Numeric Keypad 38
- 4.2 Parameter Setup 40
- 4.3.1 Main Menus 40
- TM138 – Rev. 1.0 4-5 41
- 4-6 TM138 – Rev. 1.0 42
- TM138 – Rev. 1.0 4-7 43
- 4-8 TM138 – Rev. 1.0 44
- TM138 – Rev. 1.0 4-9 45
- 4-10 TM138 – Rev. 1.0 46
- TM138 – Rev. 1.0 4-11 47
- 4-12 TM138 – Rev. 1.0 48
- TM138 – Rev. 1.0 4-13 49
- 4-14 TM138 – Rev. 1.0 50
- TM138 – Rev. 1.0 4-15 51
- 4-16 TM138 – Rev. 1.0 52
- TM138 – Rev. 1.0 4-17 53
- 4-18 TM138 – Rev. 1.0 54
- TM138 – Rev. 1.0 4-19 55
- 4-20 TM138 – Rev. 1.0 56
- TM138 – Rev. 1.0 4-21 57
- 4-22 TM138 – Rev. 1.0 58
- TM138 – Rev. 1.0 4-23 59
- 4-24 TM138 – Rev. 1.0 60
- TM138 – Rev. 1.0 4-25 61
- 4-26 TM138 – Rev. 1.0 62
- TM138 – Rev. 1.0 4-27 63
- 4-28 TM138 – Rev. 1.0 64
- 4.4 Terminal Mode Control 65
- 4.6 Connecting the Terminal 66
- 4.7 Terminal Screens 66
- TM138 – Rev. 1.0 4-31 67
- Rear Panel Interfaces 68
- 5-2 TM138 – Rev. 1.0 69
- 5.3.5 EXT CLK (J16) 70
- 5.3.7 (J18) 70
- 5.3.8 EIA-530 (J19) 71
- 5.3.9 REMOTE (J20) 72
- 5-6 TM138 – Rev. 1.0 73
- 6.0 Periodic Maintenance 74
- 6.0.1 Clock Adjustment 74
- 6.1 Troubleshooting 74
- 6.1.1 Alarm Faults 75
- 6.1.1.1 Major Tx Alarms 75
- 6.1.1.2 Major Rx Alarms 76
- 6.1.1.3 Minor Tx Alarms 76
- 6.1.1.4 Minor Rx Alarms 77
- 6.1.1.5 Common Major Alarms 77
- TM138 – Rev. 1.0 6-5 78
- 6-6 TM138 – Rev. 1.0 79
- Technical Specifications 80
- 7.2 Demodulator 81
- 7.3 Monitor and Control 81
- TM138 – Rev. 1.0 7-3 82
- 7-4 TM138 – Rev. 1.0 83
- 7.8.2 DVB 84
- 7-6 TM138 – Rev. 1.0 85
- TM138 – Rev. 1.0 7-7 86
- 7-8 TM138 – Rev. 1.0 87
- TM138 – Rev. 1.0 7-9 88
- Product Options 89
- A-2 TM138 – Rev. 1.0 90
- B.0 Introduction 91
- B.1 Required Equipment 91
- B.2 Upgrade Procedure 91
- B-2 TM138 – Rev. 1.0 92
- B.3 Demonstration Procedure 93
- B-4 TM138 – Rev. 1.0 94
- TM138 – Rev. 1.0 95
- B-6 TM138 – Rev. 1.0 96
- Carrier Control 98
- C.5 Carrier RTS 99
- TM138 – Rev. 1.0 C-3 100
- Strap Codes 101
- D.1 Sample Applications 104
- TM138 – Rev. 1.0 D-5 105
- D-6 TM138 – Rev. 1.0 106
- TM138 – Rev. 1.0 D-7 107
- Glossary 108
- G-2 TM138 – Rev. 1.0 109
- TM138 – Rev. 1.0 G-3 110
- G-4 TM138 – Rev. 1.0 111
- TM138 – Rev. 1.0 G-5 112
- G-6 TM138 – Rev. 1.0 113
Relacionado con productos y manuales para Modulador Radyne DMDVB20 LBST
Modulador Radyne DM240XR Especificaciones
(196 paginas)
(196 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.030 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales