Radyne DM240XR Especificaciones descargar pdf (Pagina 175)

MN-DM240XR– Revision 13 C–1

Appendix C. Web Browser Quick

Setup Guide

C.1 Introduction

The DM240XR Web Browser allows for connection to Radyne products through the Ethernet

port. The Web interface allows for complete control and monitoring of all equipment parameters

and functions via a 10Base-T Ethernet connection. Utilization of the Web browser is dependent

upon proper set-up of the TCP-IP menus. For TCP-IP setup guidelines refer to Appendix G in the

manual. For additional information on the various WEB configurations and descriptions refer to

the Section 10.

To verify that the Radyne product is configured with the Web interface, use the products front

panel <SYSTEM> control screen and verify that the WEB sub menu is visible. Contact the

Radyne Customer Service Department if the WEB feature is not displayed on the front panel to

identify the product is upgradeable.

Utilization of the Web Browser requires proper setup of the TCP-IP menus. The unit is

shipped from the factory with the Boot Mode configured as Default. Verify that the

Boot Mode is set for Default. To access the unit via the Ethernet port, set the Boot

Mode to IP TEST. This will set the IP parameter to an accessible address. If user

wants to utilize an alternate address, user must set the Boot Mode to NON-VOL.

Contact the IT manager for proper guidance to ensure setup is successful.

C.2 Web Users Configuration

IMPORTANT

1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 195 196

Sin comentarios

Radyne DM240XR Especificaciones Pagina 175